Configure Meeting Connector Controller Port Forwarding Follow

The following is an example of configuring your Meeting Connector (MC) Controller using port forwarding on your firewall.

*Note: With port forwarding, end-to-end encryption will not be supported during meetings.

One Meeting Connector Controller (350 Participants)

Your network information:

External IP address: 173.228.57.201
Internal IP address (assigned to MC): 10.251.10.123

Firewall Setup:

Forward 173.228.57.201 TCP/UDP 9001 > 10.251.10.123 TCP/UDP 8802
Forward 173.228.57.201 TCP/UDP 9002 > 10.251.10.123 TCP/UDP 8801

Controller Configuration:

 

Two Meeting Connector Controllers

Your network information:

External IP address: 173.228.57.201
Internal IP address (assigned to MC-1): 10.251.10.123
Internal IP address (assigned to MC-2): 10.251.10.124

Firewall Setup:

Forward 173.228.57.201 TCP/UDP 9001 > 10.251.10.123 TCP/UDP 8802
Forward 173.228.57.201 TCP/UDP 9002 > 10.251.10.123 TCP/UDP 8801
Forward 173.228.57.201 TCP/UDP 9003 > 10.251.10.124 TCP/UDP 8802
Forward 173.228.57.201 TCP/UDP 9004 > 10.251.10.124 TCP/UDP 8801

Controller 1 Configuration:

Controller 2 Configuration:

Was this article helpful?
Have more questions? Submit a request
Powered by Zendesk