Configure Meeting Connector Controller 1:1 NAT Follow

The following is an example of configuring your Meeting Connector (MC) Controller using 1:1 NAT to an external IP address.

*Note: To enable end-to-end encryption for your MC Controller, please see Configure Meeting Connector Controller 1:1 NAT with end-to-end encryption

One Meeting Connector Controller (350 participants)

Your network information:

External IP address (for MC): 173.228.57.201
Internal IP address (assigned to MC): 10.251.10.123

Firewall Setup:

Set up 1:1 NAT 173.228.57.201 > 10.251.10.123

Contoller Configuration:

 

Two Meeting Connector Controllers (700 participants)

Your network information:

External IP address (for MC-1): 173.228.57.201
Internal IP address (assigned to MC-1): 10.251.10.123
External IP address (for MC-2): 173.228.57.202
Internal IP address (assigned to MC-2): 10.251.10.124

Firewall Setup:

Set up 1:1 NAT 173.228.57.201 > 10.251.10.123
Set up 1:1 NAT 173.228.57.202 > 10.251.10.124

Controller 1 Configuration:

Controller 2 Configuration:

Was this article helpful?
Have more questions? Submit a request
Powered by Zendesk