Note: We are experiencing longer wait times than normal due to increased demand. You can still view answers to frequently asked questions or contact us but wait times may be longer than expected. Thank you for your patience.

Configuring Meeting Connector Controllers for 1:1 NAT Follow

Overview

The following is an example of configuring your Meeting Connector (MC) Controller using 1:1 NAT to an external IP address. 

Note: SSL is enabled for End-to-End Encryption on all servers. 

One Meeting Connector Controller (350 participants)

Example Network Information:

  • Internal IP address for ZC: 10.100.124.238
  • External IP address assigned to ZC: 173.288.57.204
  • Internal IP address for MMR: 10.100.124.237
  • External IP address assigned to MMR: 173.288.57.203

Example Firewall Setup for 1:1 NAT:

  • ZC: 173.228.57.204 > 10.100.124.238
  • MMR: 173.288.57.203 > 10.100.124.237

Example Controller Configuration:

Two Meeting Connector Controllers (700 participants)

Example Your network information:

Zone Controller 1

  • Internal IP address for ZC: 10.100.124.238
  • External IP address assigned to ZC: 173.288.57.204
  • Internal IP address for MMR: 10.100.124.237
  • External IP address assigned to MMR: 173.288.57.203

Zone Controller 2

  • Internal IP address for ZC: 10.100.124.236
  • External IP address assigned to ZC: 173.288.57.202
  • Internal IP address for MMR: 10.100.124.235
  • External IP address assigned to MMR: 173.288.57.201

Example Firewall Setup for 1:1 NAT:

  • ZC-1: 173.228.57.204 > 10.100.124.238
  • MMR-1: 173.288.57.203 > 10.100.124.237
  • ZC-2: 173.228.57.202 > 10.100.124.236
  • MMR-2: 173.288.57.201 > 10.100.124.235

Example Controller 1 Configuration:

Example Controller 2 Configuration:

Was this article helpful?